• The aircraft power on blue light flashes quickly and fails to pass the horizonta
    Put the plane level and then turn on the power. Test it a few more times, or try again in a few minutes.
  • The remote control lever screw falls?
    Product accessories are defective. If this happens, first make sure the nut is still there. If it is, ask the customer to screw it up. If the screw teeth are not enough, you can disassemble the remote control, remove the gasket inside, and then bring the screw.
  • The charger cannot be charged. The indicator light of the charger is abnormal. T
    The adapter used by the charger shall not be greater than 5v-2a output power, otherwise it will damage the charger Using a computer or low-power output head may cause the abnormal display of the charging indicator. Just change an adapter with a slightly higher current The light of the 6-port c
  • After flying for a minute or two, the picture transmission is lost, the landing
    The interference factor is relatively large, so the customer needs to change a wider place and test in a place with less interference. If it still doesn't work, there is a problem with the image transmission chip, and the flight control needs to be changed.
  • The power on time is too long, the picture of glasses is white and the picture t
    The first batch will have similar problems, that is, if there is a problem within 4 minutes of normal flight, it is necessary to change the camera or add a hot plate. If it is powered on for a long time after 4 minutes, it is a normal phenomenon. Tell the customer not to power on for too long.
  • The glasses cannot be frequency matched, or there is no picture and no picture t
    Whether the frequency alignment method is correct, change glasses to test whether the frequency alignment can be performed Check whether the connecting line between the camera and flight control is loose and whether the line is abnormal. The camera needs to be replaced
本站部分图文来源网络,如有侵权问题请通知我们处理!