1) Whether the base stations are placed in the order of the instructions; 2) If the connection with repeater cannot be calibrated (restarting all base stations and reconnecting repeaters are not allowed), restart base station 0 and select WiFi connection calibration; 3) Use WiFi connection for calib

1) Recalibrate the base station (record positioning); 2) The orientation and spacing of aircraft nose shall be in accordance with the requirements of the manual and placement drawing; 3) Replace the dance step self-test, and then select the dance step self-test to fly; 4) Whether the standby time is

1) Before the first flight in the new site, it is recommended to calibrate all aircraft once; 2) The placement of the base station is longer and wider than the schematic placement of the dance steps; 3) If the ground is reflective, the flight area can be paved with cloth or carpet; 4) Avoid the use

1) If WiFi connection is used, replace it with repeater connection; 2) If the repeater is connected, reconnect the repeater to ensure that the repeater faces the aircraft and base station; 3) Restart the plane.

1) The machine head shall be placed according to the schematic diagram; 2) The base station shall be placed clockwise according to the requirements of the manual, and the side with the indicator light on shall be opposite to each other diagonally; 3) Recalibrate the base station to ensure the correc

When using the formation product for the first time, the user can record the positioning, input the correct heading angle and calibrate the magnetism. Then, when viewing the status of a single aircraft, click the take-off button to see whether the aircraft hovers normally. Or after magnetic calibrat

Solution: for the environment below 5 degrees, due to the discharge activity of lithium battery, it can not be used at low temperature even when it is fully charged. The solution is to store the fully charged battery in an incubator at about 25 degrees. Usually, a hot water bag can be used for insul

This usually occurs because the aircraft IMU is still in motion and has not yet entered the static state. At this time, it is necessary to wait for the aircraft to stand still for one or two minutes or restart the aircraft. The uneven ground on which the aircraft is placed may also lead to the non c

In case of non low power drop or other abnormalities of the aircraft, do not shut down the equipment. Enter the problematic aircraft status page on the app interface, click log download, and then return to the user menu of the app - General (setting) - fault repair report to fill in the information.